Our Stage 2 Torque Arm Insert is aimed at maximizing performance while still maintaining most daily-driving comforts. However, these Stage 2 torque arm inserts are made of 90a durometer polyurethane, so do expect some reduction in comfort due to increase noise and vibrations. These Stage 2 inserts are best suited for the enthusiast looking for maximum performance and vehicles that are track-prepped. Under hard acceleration, the pendulum mount (commonly referred to as the "dogbone" or by VW as the "torque arm") acts to limit rotational movement of the engine. The factory bushings do a satisfactory job, while limiting vibrations, but only during sedate driving conditions. When pushed hard, those bushings flex creating a vague feeling in the engine and gearbox and adding to the dreaded wheel hop phenomenon. Our pendulum mount torque arm insert fills the voids in the stock rubber bushing, making what was a soft rubber bushing with voids into what behaves like a solid mount. With the insert installed, you will notice that throttle response will feel better and your shifts will feel more crisp and defined, especially on manual transmission cars. INCLUDES:
- Torque arm / dogbone polyurethane insert
- Laser cut washer
- Steel spacer
- High strength grade 10.9 replacement bolt
FITS:
- All MQB Platform Vehicles Including MK7/7.5 GOLF/GTI/R & 8V Audi A3/S3
- You may experience some in-cabin vibrations after installing our insert. These vibrations are most noticeable in reverse and while the a/c is engaged at idle. These are normal and will subdue after approximately 1,000 miles of driving. TDI models will experiencing increased NVH compared to gasoline vehicles due to the design of the diesel engine.
