Free In-Store Flashing and Consultation!
There is no extra charge for flashing at our shop if you do not wish to purchase the flashing cable. Updates and/or re-flash are also complimentary as long as the tune was purchased from us and applicable to the original purchaser.
Description
Performance Software Precisely Engineered for your car.
Subject to ECU Box code availability.
Subject to ECU Box code availability.
Oil and Additives Recommendation
Unitronic uses and recommends Liqui Moly Oil & Additives exclusively for your vehicle, which meet Audi/VW approvals. To ensure your vehicle is maintained with the #1 oil brand in Germany, see what is recommended for you with the
Liqui Moly Oil Guide.
Liqui Moly Oil Guide.
Stage 1 ECU
Features
- Engineered with Strict Industry Standards
- Extensively Tested Under Various Driving Conditions
- Factory Safety Limiters Retained
- Advanced Torque Management by Gear (For maximum acceleration)
- Engine Temperature Protection (Rev Limit based on Engine Coolant Temperature)
- Optimized Responsiveness and Drivability
- Optimized Smoothness and Driving Comfort
- Power Delivery Perfectly Optimized Throughout the Power Band
- Improved Fuel Efficiency
- Ignition Timing Precisely Calibrated for Higher Octane Fuel
- Speed Governor Removed
Related Hardware
- Carbon Fiber Intake System With Air Duct For 1.8/2.0 TSI Gen3 MQB
- Intercooler Upgrade Kit for 1.8 and 2.0 TSI Gen3 MQB and 8Y S3 by Unitronic
- MQB Turbo Inlet Elbow
Stage 1+ ECU
Features
- Engineered with Strict Industry Standards
- Extensively Tested Under Various Driving Conditions
- Factory Safety Limiters Retained
- Advanced Torque Management by Gear (For maximum acceleration)
- Engine Temperature Protection (Rev Limit based on Engine Coolant Temperature)
- Optimized Responsiveness and Drivability
- Optimized Smoothness and Driving Comfort
- Power Delivery Perfectly Optimized Throughout the Power Band
- Improved Fuel Efficiency
- Ignition Timing Precisely Calibrated for Higher Octane Fuel
- Speed Governor Removed
- Includes all Stage 1+ tune variants and all lower software stages.
Related Hardware
- Carbon Fiber Intake System With Air Duct For 1.8/2.0 TSI Gen3 MQB
- Intercooler Upgrade Kit for 1.8 and 2.0 TSI Gen3 MQB and 8Y S3 by Unitronic
- MQB Turbo Inlet Elbow
Stage 2 ECU
Features
- Engineered with Strict Industry Standards
- Extensively Tested Under Various Driving Conditions
- Factory Safety Limiters Retained
- Advanced Torque Management by Gear (For maximum acceleration)
- Engine Temperature Protection (Rev Limit based on Engine Coolant Temperature)
- Optimized Responsiveness and Drivability
- Optimized Smoothness and Driving Comfort
- Power Delivery Perfectly Optimized Throughout the Power Band
- Improved Fuel Efficiency
- Ignition Timing Precisely Calibrated for Higher Octane Fuel
- Speed Governor Removed
- Includes all Stage 2 tune variants and all lower software stages.
- Exhaust Overrun/Crackle Enabled with Stage 2 and up on North American vehicles. Requires UniConnect+ cable. Subject to availability.
Required Hardware
- Unitronic Performance Downpipe 2.0 TSI MQB EA888.3 AWD
- Unitronic Performance Downpipe 2.0 TSI MQB EA888.3 FWD
Recommended Hardware
- Carbon Fiber Intake System With Air Duct For 1.8/2.0 TSI Gen3 MQB
- Cat-Back for MK7 & MK7.5 GTI, Chrome Tips, by Unitronic
- Charge Pipe Upgrade Kit For MQB
- Intercooler Upgrade Kit for 1.8 and 2.0 TSI Gen3 MQB and 8Y S3 by Unitronic
- MQB Turbo Inlet Elbow
Stage 1 DSG
Features
Stage 1 DSG Software Precisely Engineered to run combined with a Unitronic Stage 1 or 1+ performance software.
- Engineered with Strict Industry Standards
- Extensively Tested Under Various Driving Conditions
- Optimized Responsiveness and Drivability
- Optimized Smoothness and Driving Comfort
- Rpm Limiter Increased to 6800
- Optimized "D" and "Sport Mode
- Gear Display Enabled in D and S Mode
- Launch Control increased to 3600
- Optimized cruising upshift setpoint for maximum responsiveness
- Sport Mode Wide Open Throttle Upshifts optimized for maximum acceleration
Features
Stage 2 DSG Software Precisely Engineered to run combined with a Unitronic Stage 2 or Stage 2+ performance software.
- Engineered with Strict Industry Standards
- Extensively Tested Under Various Driving Conditions
- Optimized Responsiveness and Drivability
- Optimized Smoothness and Driving Comfort
- Rpm Limiter Increased to 6800
- Optimized "D" and "Sport Mode
- Kick Downs Removed in Manual Mode*
- Gear Display Enabled in D and S Mode*
- Launch Control increased to 4000
- Optimized cruising upshift setpoint for maximum responsiveness
- Sport Mode Wide Open Throttle Upshifts optimized for maximum acceleration
- *Feature may not be available for all TCU types/box codes
- Includes all Stage 2 tune variants and all lower software stages as well.
Unitronic's UniCONNECT+
Description
UniCONNECT+ is a Programming and Diagnostic Interface which gives users the freedom to reflash their Engine Control Unit (ECU) or Transmission Control Unit (TCU) from the comfort of their own garage. With the ability to upgrade the Unitronic Performance Software, flash back to stock, and also perform diagnostics, UniCONNECT+ is a complete end-user programming and diagnostic interface that provides control over your vehicle.
Availability
UniCONNECT+ is available for purchase through our Authorized Dealer Network and directly from Unitronic. UniCONNECT+ is compatible with most of 2006 and up vehicles.*
Simple Installation
UniCONNECT+ gives you the freedom to effortlessly install your Unitronic Performance ECU and DSG Software from the comfort of your own home or garage.*
Unitronic recommends the use of these battery chargers to ensure, uninterrupted, trouble-free, flashing at home!
OptiMate 7 SELECT
OptiMate 6 SELECT
Unitronic recommends the use of these battery chargers to ensure, uninterrupted, trouble-free, flashing at home!
OptiMate 7 SELECT
OptiMate 6 SELECT
Change Software Maps
Quickly and Easily re-flash your ECU with Performance Software maps designed and specifically calibrated to suite the hardware and fuel modifications or fuel grade used.
Data Logging
Gathering high resolution data is made easy with Unitronic’s pre-configured channel loadouts for fast and effortless troubleshooting and data logging.**
Simple back to factory restoration
UniCONNECT+ makes it painless to revert your ECU back to it’s stock calibration within minutes.*
Advanced Settings
Enable optional advanced settings such as Launch Control or No Lift Shifting within minutes. Enable Gear display in MFG for DSG Software owners.*
Technical Specifications
Minimum System Requirements:
Operating System: Microsoft Windows 10 or 11
Internet Explorer 11
Screen Resolution: 1024x768
Processor: 1.5 GHz or higher
Memory (RAM): 4GB or more
For optimal application performance:
Operating System: Microsoft Windows 11
Internet Explorer 11 or newer
Screen Resolution: 1024x768
Processor: 2.0 GHz or higher
Memory (RAM): 8GB or more
Internet access is required.
Operating System: Microsoft Windows 10 or 11
Internet Explorer 11
Screen Resolution: 1024x768
Processor: 1.5 GHz or higher
Memory (RAM): 4GB or more
For optimal application performance:
Operating System: Microsoft Windows 11
Internet Explorer 11 or newer
Screen Resolution: 1024x768
Processor: 2.0 GHz or higher
Memory (RAM): 8GB or more
Internet access is required.
*Some exclusions apply. UniCONNECT+ cables are VIN-locked and can only be used on one vehicle. Only available for select engines. Contact US for more information.
**Feature in development.
